Matters to be known as the manager of automatic feeding mixer truck
The operator of automatic feeding mixer truck needs to be trained and familiar with its operation rules. Xiaobian believes that as an operator of automatic feeding mixer truck, you need to do the following four aspects.
1、 Prevent concrete from sticking to the tank. After unloading at the construction site, immediately flush the inlet hopper, outlet hopper and unloading chute with the hose attached to the mixer truck, and clean the sludge and concrete adhered to the vehicle body. On the way back to the mixing plant, 150-200l water shall be injected into the mixing drum to clean the concrete residue bonded to the drum wall and blades. At the end of each day's work, the driver shall be responsible for injecting clean water into the mixing drum and rotating at high speed (14-18 RPM) for 5-10 minutes, and then drain the water to ensure the cleanness of the drum. When cleaning all parts of the mixing drum with high-pressure water, pay attention to avoid instruments, control rods and other parts. The distance between the pressure water nozzle and the paint surface of the vehicle body shall not be less than 40cm.
Automatic feeding mixer manufacturer
2、 Cleaning work. When cleaning the dirt and residual concrete slag inside and outside the mixing drum, and when the mechanical maintenance personnel enter the drum for maintenance and welding repair, it is necessary to turn off the automobile engine first to stop the mixing drum completely. During the working period when the mechanical maintenance personnel enter the drum, they must ensure that the mixing drum is well ventilated, the air is fresh, there is no combustible gas and harmful dust, and the oxygen supply is sufficient. When using electric tools in the cylinder, the operator must have good insulation protection.
3、 Protection work. When the automatic loading mixer works, do not put your hand into the rotating mixing drum, and do not put your hand into the connecting part of the main unloading frying groove and the extended unloading frying groove, so as to avoid accidents.
4、 The pressure of the hydraulic system shall comply with the provisions in the operation manual and shall not be adjusted at will. The oil quality and quantity of hydraulic oil shall meet the original requirements.
The above is a detailed introduction to the automatic feeding mixer truck. I hope it will be helpful to you If you have any questions, please contact us We will provide you with professional service /